Omron SYSMAC C200HS Operation Manual page 444

Standard Models
Optical Power Tester
Name
Optical Power Tester (see note)
(provided with a connector adapter,
light source unit, small single-head
plug, hard case, and AC adapter)
Note: There is no difference between the light source unit and connector adapter for the Head Unit and those for
the Optical Power Tester.
Head Unit
Name
Head Unit (a set consisting of light
source unit and connector adapter)
(see note)
Note: Use a proper Head Unit model for the optical module to be used. If two types of optical modules (unit type
and board type) are used, order an Optical Power Tester plus a proper Head Unit model.
Master Fiber Set
Name
Master Fiber Set (1 m)
Note 1. The Master Fiber Set is used in combination with the Optical Power Tester to check the optical levels of
optical fiber cables connected to optical fiber cable connectors.
2. Optical fiber cables must be prepared and connected by specialists.
3. The Optical Power Tester, Head Unit, Master Fiber set, and Optical Fiber Assembling Tool are required
to connect optical fiber cables.
SYSMAC LINK/SYSMAC NET Link Optical Fiber Products
Optical Fiber Cables for SYSMAC LINK and SYSMAC NET Link Systems
Use hard-plastic-clad quartz optical fiber (H-PCF) cables for SYSMAC LINK and SYSMAC NET Link Systems.
H-PCF cables are available with connectors already attached, or cables and connectors can be purchased sepa-
rately and assembled by the user. Refer to the System Manual for the SYSMAC LINK or SYSMAC NET Link Sys-
tems for assembly procedures. Models numbers for H-PCF cables with connecters attached are provided in the
following illustration.
440
Specifications
SYSMAC BUS:
C200H-RM001-PV1
C200H-RT001/RT002-P
C500-RM001-(P)V1
C500-RT001/RT002-(P)V1
SYSMAC BUS:
C200H-RM001-PV1
C200H-RT001/RT002-P
SYSMAC NET:
S3200-LSU03-V1/LSU03-01E
C500-SNT31-V4
3G8FX-TM111
3G8SX-TM111
S3200-CAT3202 (SYSMAC NET, NSB, NSU, Bridge)
S3200-CAT2002/CAT2702 (SYSMAC NET, SYSMAC
LINK)
S3200-CAT2822 (SYSMAC BUS)
Model Numbers for H-PCF Cables with Connectors
S3200-CNjjj-jj-jj
Cable length
201: 2 m
501: 5 m
102: 10 m
152: 15 m
202: 20 m
Blank: Over 20 m
(Specify.)
Head Unit
S3200-CAT2822
(provided with the
Tester)
Specifications
Specifications
Connectors
20-25: Full-lock connector on
one end, half-lock con-
nector on other end.
25-25: Half-lock connectors
on both ends.
Appendix A
Model number
S3200-CAT2820
Model number
S3200-CAT2822
S3200-CAT3202
Model number
S3200-CAT3201
S3200-CAT2001H
S3200-CAT2821