Omron SYSMAC C200HS Operation Manual page 298

Programmable controllers

Hide thumbs Also See for SYSMAC C200HS:

Table of Contents

Special Instructions

In the following example, the FPD(––) is set to display the bit address and mes-

sage ("ABC") when a monitoring time of 123.4 s is exceeded.

FPD(––) is executed and begins monitoring when LR 0000 goes ON. If LR 0015

does not turn ON within 123.4 s and IR 10000 through IR 10003 are all ON,

IR 10002 will be selected as the cause of the error, an FAL(06) error will be gen-

erated with an FAL number of 10, and the bit address and preset message

("10002–1ABC") will be displayed on the Peripheral Device.

T is not BCD.

C is not a constant or the rightmost two digits of C are not BCD 00 to 99.

Indirectly addressed DM word is non-existent. (Content of :DM word is

not BCD, or the DM area boundary has been exceeded.)

ON when the time between the execution of FPD(––) and the execution

of a diagnostic output exceeds T.

Address Instruction

Indicates information, normally closed condition

"C", and CR code

The last two words are ignored.

(Displayed as spaces.)

Section 5-25

Show Quick Links

Chapters

Table of Contents