Omron SYSMAC C200HS Operation Manual page 430

Host Link Commands
11-3-27 FORCED SET/RESET CANCEL –– KC
Command Format
Response Format
11-3-28 PC MODEL READ –– MM
Command Format
Response Format
Forced set/reset/cancel Data (Command)
A separate hexadecimal digit is used to specify the desired process for each bit
in the specified word, bits 00 to bit 5. The bits that are merely set or reset may
change status the next time the program is executed, but bits that are force-set
or force-reset will maintain the forced status until it is cleared. If the item speci-
fied under "Name" is a timer or counter, the status of the Completion Flag can be
force-set or force-reset using bit 15, and all other bits will be ignored. Only force-
setting and force-resetting are possible for timers/counters.
Bits 00 to 15
00
02
03
04
05
08
Note The item specified under "Name" must be in four characters. Fill any gaps with
spaces to make a total of four characters.
Cancels all forced set and forced reset bits (including those set by FORCED
SET, FORCED RESET, and MULTIPLE FORCED SET/RESET). If multiple bits
are set, the forced status will be cancelled for all of them. It is not possible to can-
cel bits one by one using KC.
@
@ x 10
Reads the model type of the PC.
@
1
x 10 x 10
@
Node no.
Bit status not changed
Reset
Set
Forced-reset
Forced-set
Forced set/reset status cancel
1 0
x 10 x 10
K C
Node no. Header
code
1 0 1
x 10 K C x 16
Node no. Header End code
code
1 0
x 10 x 10
M M
Node no. Header
code
0 1 0
x 16 x 16
M M
Header End code
code
Section 11-3
Setting
: ↵
FCS Terminator
: ↵
0
x 16
FCS Terminator
: ↵
FCS Terminator
:
1 0
x 16 x 16
Model FCS Terminator
code
↵
425