Figure 3.9
3.8.4.1
PCR Embedded in Audio
When configuring an audio component with embedded PCR, the PCR PID is not
automatically updated to match the audio component PID. You must configure the
PCR PID in the service properties to match the audio component PID. Failure to do
this may result in the output being non-decodable, depending upon the receiving
device.
3.8.5
How to Set Up Pass-thru Transport Streams
The AVP supports Transport Stream content Pass-thru. That means that a
Transport Stream on an ASI input interface can be passed through to the Satellite
Modulator, G.703 or IP Output interface in a content preserving mode.
3.8.5.1
Configuration
To configure a Transport Stream Pass-thru, select the ASI Transport Stream in the
Input widget on Advanced tab of the Service Configuration page, and simply
drag-and-drop to the Satellite Modulator or IP Output Stream in the Output widget.
When the cursor is above the output an information pop-up is displayed indicating
that a Pass-thru Transport Stream will be created.
EN/LZT 790 0023/1 R16A
Setting PCR PID Value
Getting Started
3-21