Ericsson AVP 1000 Reference Manual page 60

Getting Started
Note: It is good practice to configure a Transport Stream by setting the Bit rate
5. To set up internally generated ATSC tables, see Chapter 5, Web GUI Control.
6. To create a service in the newly created Transport Stream, make sure the
Figure 3.6
Note: Transport Streams and services can also be added through the Action
7. Expand the nodes in the Inputs widget and select the video stream to be
8. Hold down the left mouse button and drag it over the newly created service.
3-18
tracking mode to Maximize Video. In this way, any changes in the
Transport Stream bit rate will be reflected in the video component bit rates.
Moreover, on the Satellite Modulator output, the Transport Stream bit rate is
determined by the modulation parameters. Any change in the modulation
parameters will also be reflected in the bit rate of the video component.
Transport Stream is selected. Right click on it and select Add Service from the
context menu, as shown in Figure 3.6. The properties of the newly created
service shall appear in the Service accordion panel of the Properties widget.
Adjust the service properties as required.
Service Configuration Web Page – Adding a Service
menu in the Outputs widget.
included in the Transport Stream.
Once the component is over the service, the color of the dragging box changes
to green indicating that the component is now over a valid dropping position.
EN/LZT 790 0023/1 R16A