Ericsson AVP 1000 Reference Manual page 135

PMT Pid
Logical Channel
PCR PID
Scrambling
BISS SW
BISS ESW
Current State
Change State
Transport Stream ID
Network Name
Network ID
Mode
PSI-SI Level
Send Extended NIT (SIRG)
PMT Repetition Period
Transport Stream Bit Rate
Bit Rate Tracking Mode
Auto Enable
Auto Disable
G.703 Transceiver (Slot <m>)
Add New Transport Stream
Add Existing Transport Stream
EN/LZT 790 0023/1 R16A
PID assigned to the PMT that describes the current service.
Appears in the NIT and provides a default channel number label for
the current service.
PID of the TS packets that carry the clock reference for the current
service. If the service has a component with the Embedded PCR
parameter set to On, this field contains the PID of that particular
video stream and it is read only.
Off, BISS-1, BISS-E. Disables or enables the scrambling of the
current service by the Basic Interoperable Scrambling System with
or without encrypted keys.
The 12 hexadecimal digit clear session word used for scrambling
the current service. Visible only if BISS-1 is selected for Scrambling.
The 16 hexadecimal digit encrypted session word used for
scrambling the current service. Visible only if BISS-E is selected for
Scrambling. The key entered here is encrypted by the BISS Injected
ID found under Advanced/System/Base Unit.
The Setmode state of the Transport Stream. Read only parameter.
Sets the Setmode state of the Transport Stream. The options
available depends on the value set for MGP Mode under
Advanced/System/MGP Support.
The label to identify the current Transport Stream from any other
multiplex within a network.
The network name as used in the NIT.
The network ID as used in the NIT.
CBR, VBR.
Off, On (PAT, PMT only), On (PAT/PMT/SDT/CAT/NIT). Sets which
tables are inserted into the Transport Stream.
On, Off. Determines whether Carrier ID is to be inserted in the NIT.
Available only when the PSI-SI Level is set so that NIT is generated.
The repetition interval of the PMT table expressed in ms.
The Bit Rate of the Transport Stream.
Off, Maximise video. Enables or disables Bit Rate tracking for the
current Transport Stream.
If set to true, it automatically re-enables the Transport Streams
when all the specified error conditions are cleared.
Never, Audio Lost, Video Lost, Any Upstream CRITICAL Alarm, Any
CRITICAL alarm. Disables the output when the set condition is met.
The Transport Stream can be set to be re-enabled at the Auto
Disable option.
Selects the G.703 Transceiver card.
Adds a new Transport Stream to the output. Displayed only if no
Transport Stream is defined for the ASI output.
Creates a copy of an existing Transport Stream at the current
output. Displayed only if no Transport Stream is defined for the ASI
output.
Front Panel Control
4-19