Ericsson AVP 1000 Reference Manual page 78

Getting Started
Interleaved
The 4K picture is broken up into sub pictures by dividing the original picture using
the two sample interleaved division as shown below. See SMPTE 425-3 and 425-5
for more information.
Figure 3.17 4K Video - Interleaved
Configuration
To set up 4K video encoding for a service on the Service Configuration page,
proceed as follows:
Note: This procedure assumes that a service has already been created. If not, one
1. In the Inputs widget, select Video 1 Main Video Stream.
2. Drag the selected component to a service in the Outputs widget.
3. In the Outputs widget, click on the video component.
Note: If you click on Audio Stream 1 in the Inputs widget, the corresponding
4. In the Properties widget, click on the Input tab.
5. Set the Source to SDI.
6. Set the Video Input Format to one of the following depending on the input
3-36
must be created before continuing. See section 3.25.3.
audio stream will be highlighted in grey in the Outputs widget.
format described above and the video frame rate:
a UHD 2160p50 Interleaved.
b UHD 2160p59.94 Interleaved.
EN/LZT 790 0023/1 R16A