Ericsson AVP 1000 Reference Manual page 75

Repeat for all required input formats
Figure 3.14 Set-up Procedure for Auto Detect and Restore Saved Config
EN/LZT 790 0023/1 R16A
Repeat for each stored config
Identify which input formats need
operational requirements
FULLY Configure unit for required
input format operation (eg SD 25Hz)
with Auto Detect set to OFF
Save as a Stored Configuration and
name appropriately.
N
All required
configs stored
Y
Load stored config n onto unit.
Enable "Auto Detect and Configure –
use stored configs" and select the
required config to be used sof each
required source.
Save the modified configuration in
the same stored config location.
N
All required configs
modified and stored?
Y
Unit is ready to use – any of the
stored configurations can be loaded
at any time and the auto detect and
configure operation will continue to
function.
Getting Started
Note that when no stored configs are
available no options will be presented for
selection when trying to configure "Auto
Detect and Configure – use stored config",
so no point setting it yet!
Once all required stored configs are
available "Auto Detect and Configure –
use stored config" can be configured as
required.
It is not absolutely necessary to do this for
every configuration, but would ensure that
the unit would continue to operate in the
same way if any of the stored configs were
manually loaded onto the unit.
3-33