Ericsson AVP 1000 Reference Manual page 145

Reflex TTL
Set Rate Timeout Period
Output Stream List
MGP Support
Supported MGP Version
MGP Mode
Transmission Interval
R0 Playout Period
S1 Playout Period
Control Contact Timeout
MSM Destination Port
MGP Settings
MSM Multicast Address
MGP State
MGP Spares
Spare Device Configuration
Vlan Tags
Output <n>: Data Port <m> - Data Port <k>
Add Vlan tag
Vlan ID: <id>
SNMP
System Contact
System Name
EN/LZT 790 0023/1 R16A
1
Spare IP Address
Vlan ID (Create)
Vlan IP
Vlan Netmask
Vlan Gateway
The time to live value to be applied to all Reflex v5 messages
transmitted from the current unit.
The maximum number of video frames between set rate messages. If
exceeded, Set Rate Message Timeout Alarm is triggered.
Lists the output reflex streams. Empty in this release as Reflex is not
supported.
The MGP version supported by the unit. Read only parameter.
Off, Module Level, Unit Level. Determines if MGP is enabled or not, or
if it is enabled, then the unit is controlled as a whole or on a module
level basis.
Period for steady-state transmission of MSM packets in units of ms.
Duration of the MSM burst emitted on entering MGP state R0 in units
of ms.
Duration of the MSM burst emitted on entering MGP state S1 in units
of ms.
Period of time in ms the system waits before assuming loss of contact
with the control system after the control link goes down.
UDP port for sending MGP packets.
1
Only available when MGP is enabled
The destination IP Address of the MSM packets.
The current state of the MGP implementation.
Selects a spare device to set up its parameters.
The IP address of another unit that is acting as a spare for this
unit/service.
Selects output <n> for adjusting its VLAN settings.
Adds a new VLAN tag to the current output.
The ID associated with the VLAN tag. Allows the user to change the
ID.
Modifies the VLAN ID for the current tag.
Assigns an IP address to the VLAN.
Specifies the network mask for the current VLAN.
Specifies the gateway address for the current VLAN.
Contact to the team providing support for this unit.
The name to identify the current unit.
Front Panel Control
4-29