Ericsson AVP 1000 Reference Manual page 61

Figure 3.7
9. Release the left mouse button. The component is added to the newly created
10. Adjust the video properties as required.
11. Add all the required components (audio, VBI...) from the Inputs widget to the
Note: To identify the source of a certain component in the Outputs widget, click
12. Modifying the same parameter for different items of the same type (for instance,
13. If you want to create another service or Transport Stream, repeat the steps
14. Turn the Transport Streams online by selecting the Transport Stream and
Note: Turning the Transport Stream online does not turn the modulator output on.
15. The Satellite Modulator output and modulation parameters can be configured
EN/LZT 790 0023/1 R16A
Service Configuration Web Page – Adding a Component
service and its parameters are shown on separate tabs in the Video
Component accordion panel of the Properties widget.
Transport Stream as above. Adjust the component parameters in the respective
accordion panel of the Properties widget.
on the component. The source of the component is highlighted in grey in the
Inputs widget. You may have to scroll in the Inputs widget to actually see
the highlighted component.
the bit rate of two or more audio components) can be carried out by selecting all
the items, navigating to the property to be changed, and changing the value. If
the values for the selected items are different, then the string [Mixed] is shown
in the respective field.
above.
clicking on the Online button in the Properties widget.
The additional steps below are needed.
from the Service Configuration>Satellite Modulator>Properties tabs. For the
output to be transmitted, in addition to the TS being set Online, the output state
Getting Started
3-19