Ericsson AVP 1000 Reference Manual page 260

Web GUI Control
Parameter Options
Audio Description Service
Table 5.55 MPEG Layer 2 Parameters
Parameter Values
Bit Rate 32, 48, 56, 64, 80, 96, 112, 128, 160, 192, 224,
256, 320, 384
Coding Mode 1/0 (Left - input), 1/0 (Right - input), 1/0 (L+R)/2,
1+1 (L/Ch1, R/Ch2), 2/0, 2/0 (Joint), Phase
Aligned Audio (6 Cannels), Phase Aligned Audio
(8 Cannels)
Embedded PCR On, Off
Au Information Cont Off, AU Info
Advanced
Lip Sync Offset -500 to 500 ms
Gain -6 to 6dB
Language
Language (Left)
Language (Right)
User Language 1
User Language 2
MPEG Version MPEG1, MPEG2
Copyright Off, On
Original Off, On
De-emphasis Off, 50/15us, CCITT J.17
Table 5.56 Dolby Digital Parameters
Parameter Values
Bit Rate 56, 64, 80, 96, 112, 128, 160, 192, 224, 256,
320, 384, 448, 512, 576, 640
1/0 (Left – input), 1/0 (Right – input), 1/0 (L+R)/2,
Coding Mode
2/0, 3/2L (5.1 Surround)
5-84
Description
MPEG-1 Layer II encode of a mono audio track that
describes action in the video plus a control track.
Description
Bit Rate of the audio stream
Specifies what channel configuration to use for encoding..
Controls whether PCR is to be embedded in the audio
PES.
Controls the insertion of private data in the adaptation unit
of the audio access units (AU). AU Info is defined in ETSI
TR 101 154. Only AU_PTS is present for audio
Configures a delay to the audio to improve A/V
synchronization.
Sets the gain in dB for the audio stream.
The language of the stream when not in dual mono (1+1)
mode.
The language of the left channel when in dual mono (1+1)
mode.
The language of the right channel when in dual mono
(1+1) mode.
A custom three-character language code when User
Language 1 is set in any of the language fields.
A custom three-character language code when User
Language 2 is set in any of the language fields.
Configures if MPEG-1 or MPEG-2 to be ignaled.
Indicates if the material is copyright protected.
Indicates if source is the original or a copy
To meet the MPEG-1 Layer 2 encoding algorithm
specification the audio must not have pre-emphasis
applied. If the input signal does have pre-emphasis
applied, a de-emphasis filter must be applied prior to
encoding.
Description
Bit Rate of the audio stream. The available options depend
on the selected coding mode.
Specifies what channel configuration to use for encoding.
EN/LZT 790 0023/1 R16A