Ericsson AVP 1000 Reference Manual page 202

Web GUI Control
Figure 5.23 GPI Pin Setting via GUI
The parameters for each input pin are listed below.
Table 5.5 GPI Input Pin Configuration
Parameter Values
GPI Input Pin Mode Off (Default)
Load Stored Configuration
Splice Out of Network
Splice Return to Network
Splice Latched
5-26
Description
Only available for pins 1 to 10.
When selected and the GPI pin changes state, an Out of
network splice point is signaled to be inserted into the
Transport Stream. Further setting determines how and when
the splice point is inserted.
When selected and the GPI pin changes state, a Return to
network splice point is signaled to be inserted into the
Transport Stream. Further setting determines how and when
the splice point is inserted.
When selected and the GPI pin changes state, an Out of
network splice point is signaled to be inserted into the
Transport Stream. A return to network splice point is signalled
when either the GPI pin polarity changes state again or when
the splice duration is reached. Further setting determines how
and when the splice point is inserted.
EN/LZT 790 0023/1 R16A