Ericsson AVP 1000 Reference Manual page 133

Program Specific Information
Transport Stream ID
PAT-PMT
PAT-PMT Parameters
PMT Repetition Period
Dolby Digital Descriptor
CAT
TSTD
Service Information
Original Network ID
NIT
NIT Parameters
Network Name
Network ID
Generate LCN
Send Extended NIT - SIRG
Insert NIT into PAT
SDT
IP Bit Rate
TS Packets per IP Packet
IP Encapsulation
FEC Rows
FEC Columns
FEC Alignment
IP Output Configuration
Destination 1
Destination IP Address
EN/LZT 790 0023/1 R16A
A new ID can be assigned to the Transport Stream.
On, Off
100 ms, 400 ms, 500 ms. Specifies how often (in ms) the PMT shall
be transmitted.
DVB, ATSC, DVB & ATSC
On, Off
On, Off
On, Off
Set Network Name
Set network ID.
Off, IEC 62216, NorDig v1, DTG Default
On, Off. If PSI/SI Level is set to On (PAT/PMT/SDT/CAT/NIT) make
sure the Send extended NIT (SIRG) is On so that the Carrier ID is
sent.
True, False
On, Off
Specifies the Bit Rate of the IP output and includes the overhead
added by IP encapsulation. Read only parameter.
1 - 7. Specifies how many Transport Stream packets to encapsulate
in one IP packet.
UDP, RTP, RTP FEC Column, RTP FEC Column and Row.
Specifies what higher layer to encapsulate in IP packets. UDP and
RTP is self explanatory and means that the Transport Stream is first
encapsulated in UDP or RTP packets, then an IP header is added.
If RTP FEC column or RTP FEC Columns and Row is selected one
(Column) or two (Column and Row) RTP streams are output in
addition to the RTP streams that carry the Transport Stream.
The number of rows used in FEC encoding.
The number of columns used in FEC encoding..
Block Aligned, Non Block Aligned. The aligned method used for Pro
MPEG FEC..
Selects Destination 1.
The destination IP address to use in the IP packet header of the IP
packets that carry the Transport Stream
Front Panel Control
4-17