Ericsson AVP 1000 Reference Manual page 131

IP Redundancy Mode
Active Interface
Line Speed
Duplex Mode
Default Virtual MAC Address
IP Address
Subnet Mask
Gateway Address
IGMP mode Selection
Physical Data Interface <k>
Default MAC Address
Link Status
Link Up Time
TX Packets
RX Packets
IP Address
Add New Transport Stream
Add Existing Transport Stream
Transport Stream <l>
Transport Stream ID <id>
Service List
Add Service
Service <name>
Component List
Add Component
<Component name> on <pid>
EN/LZT 790 0023/1 R16A
Elementary Stream
Active-Active, Active-Standby. Describes the behavior of the spare
interfaces.
Read only parameter. In Active - Active redundancy mode both
interfaces are active.
Auto, 100 Mpbs, 1 Gbps. The transmission speed of the link.
Auto, Full Duplex, Half Duplex. Determines whether data are to be
transmitted and received in a time divided manner (Half Duplex) or
transmission and reception can happen at the same time over the
same link (Full Duplex). Auto is for automatic configuration.
Virtual MAC address assigned to the Data Interface Group.
The IP address associated with the interface group.
The subnet mask associated with the interface group.
The gateway address associated with the interface group.
IGMP v2, IGMP v3
The physical data interface labeled as Ge <k> of the current data
interface group.
The hardware address of the Ge <k> interface.
Link Down, Link Up. The status of the current physical data
interface.
The time in days, hours, minutes and seconds the link is
established. Read only parameter.
Packets transmitted since the link is up.
Packets received since the link is up.
The IP address of the physical data interface.
Creates a new Transport Stream for the current output.
Creates a copy of an existing Transport Stream for the current
output.
The list of the Transport Streams to copy to the current output.
Selects the Transport Stream with ID <id> to modify its parameters.
The list of services in the current Transport Stream.
Adds a new service to the current Transport Stream.
Selects the service with <name> already added to the current
Transport Stream.
List of components in the current service.
Adds a new component to the current service.
Selects the component with <component name> and <pid> already
added to the current service.
The elementary stream associated with the component produced by
one of the CE VCM modules in the unit.
Front Panel Control
4-15