Ericsson AVP 1000 Reference Manual page 114

Getting Started
Table 3.22 IP Related Parameters
Parameter
TS Packets per IP Packet
IP Encapsulation
IP Configuration/Destination 1
Destination IP Address
Destination UDP Port
Source IP Address
Source MAC Address
Source UDP Port
6. Select the Service List menu in order to add one or more services to the
7. Select Add Service. A new service by the name Service Name appears in the
8. Select Service Name.
9. Check that the parameter settings are correct.
Table 3.23 Component and Service Parameters
Parameter
Component List
Service ID
PMT PID
PCR PID
SDT Parameters
NIT Service Parameters
BISS KEY
3-72
Description
Specifies how many Transport Stream packets to encapsulate in one IP packet.
Specifies what higher layer to encapsulate in IP packets. UDP and RTP is self explanatory and
means that the Transport Stream is first encapsulated in UDP or RTP packets, then an IP header is
added. If RTP FEC column or RTP FEC Columns and Row is selected one (Column) or two (Column
and Row) RTP streams are output in addition to the RTP streams that carry the Transport Stream.
The destination IP address to use in the IP packet header of the IP packets that carry the Transport
Stream.
The destination UDP port to use in the IP packet header of the IP packets that carry the Transport
Stream.
The source IP address to use in the IP packet header of the IP packets that carry the Transport
Stream.
Read only parameter, not yet supported.
The source UDP port to use in the IP packet header of the IP packets that carry the Transport
Stream
Transport Stream.
list.
Description
Select to manage components in the service. (Next step.)
Set Service ID
A new PMT PID can be assigned to the service.
The PID to be used for the PCR.
NOTE: If PCR on separate PID is enabled, this value must match the PID given to the PCR
component in the output service.
Service Provider
Service Name
Service ID
Service Type
LCN
0 – 31 Selects the location in the BISS key table to use for BISS scrambling
Set service provider name.
Set service name. After setting the service name the service will be listed
accordingly.
A new ID can be assigned to the service.
Digital TV, Digital Radio, Teletext, Mosaic, Data Broadcast, Off, BISS
Mode-1, BISS Mode-E.
0 - 1023
EN/LZT 790 0023/1 R16A