Ericsson AVP 1000 Reference Manual page 231

Parameter Values
Delay 1000
Audio Encoding
The following parameters are available on the Encode tab of the Properties widget
on the Service Configuration page when an audio component is selected in the
Outputs widget. The same parameters can be accessed through the
Advanced/CE-a/Audio Module/Audio <n>/Encode menu on the front panel.
Table 5.17 Audio Encoding Standards
Parameter Options
Coding Standard
MPEG Layer 2
Dolby Digital
AAC-LC
HE-AAC
Pass-thru
Audio Description Service
Table 5.18 MPEG Layer 2 Parameters
Parameter Values
Bit Rate 32, 48, 56, 64, 80, 96, 112, 128, 160, 192, 224,
256, 320, 384
Coding Mode 1/0 (Left - input), 1/0 (Right - input), 1/0 (L+R)/2,
1+1 (L/Ch1, R/Ch2), 2/0, 2/0 (Joint), Phase
Aligned Audio (6 Cannels), Phase Aligned Audio
(8 Cannels)
Embedded PCR On, Off
Au Information Cont Off, AU Info
Advanced
Lip Sync Offset -500 to 500 ms
Gain -6 to 6 dB
Language
Language (Left)
EN/LZT 790 0023/1 R16A
Description
the audio processor.
Specifies the delay (in ms).
Description
MPEG Layer 2 Encode(More than two channel pairs
require the /SWO/M1L2 license)
Dolby Digital encode, requires CE/SWO/DOLBYAC3
license..
AAC-LC encoding, requires CE/SWO/AAC license.
HE-AAC or HE-AAC v2 encoding, requires CE/SWO/AAC
license.
Pass-thru of the input
MPEG-1 Layer II Encode of a mono audio track that
describes action in the video plus a control track.
Description
Bit rate of the audio stream
Specifies what channel configuration to use for encoding..
Controls whether PCR is to be embedded in the audio
PES.
Controls the insertion of private data in the adaptation unit
of the audio access units (AU). AU Info is defined in ETSI
TR 101 154. Only AU_PTS is present for audio
Configures a delay to the audio to improve A/V
synchronization.
Sets the gain in dB for the audio stream.
The language of the stream when not in dual mono (1+1)
mode.
The language of the left channel when in dual mono (1+1)
mode.
Web GUI Control
5-55