Ericsson AVP 1000 Reference Manual page 132

Front Panel Control
Service ID
PMT PID
PCR PID
SDT Parameters
Service Provider
Service Name
Service Type
NIT Service Parameters
LCN
BISS Key
BISS SW
BISS ESW
Current State
Change State
Transport Stream Bit Rate
Bit Rate Tracking Mode
Auto Enable
Auto Disable
Syntax
4-16
PID
Bit Rate Weighting
Master TS
The Packet Identifier that identifies the TS packets carrying the
current component.
Fixed, Minimum, 2-20. The weighting associated to the current
component. A component with Fixed weighting does not respond to
changes in the Transport Stream Bit Rate. If Minimum is set for a
component, it will always use the minimum Bit Rate defined for the
video profile it is encoded with. A value 2-20 determines how much
a component is changed when the Transport Stream Bit Rate is
changed relative to other components with Bit Rate weighting other
than Minimum.
Information only – master TS for Bitrate tracking
The unique identifier of the current service within the current
Transport Stream.
PID assigned to the PMT that describes the current service.
The PID of the TS packets that carry the clock reference for the
current service. If the service has a component with the Embedded
PCR parameter set to On, this field contains the PID of that
particular video stream and it is read only.
The name of the service provider as appears in the NIT.
The name of the service as appears in the NIT.
Digital TV, Digital Radio, Teletext, Mosaic, Data Broadcast.
0 - 1023
Off, 1 – 32 Enables BISS using key stored in selected location
.
The 12 hexadecimal digit clear session word used for scrambling
the current service. Visible only if BISS-1 is selected for Scrambling.
The 16 hexadecimal digit encrypted session word used for
scrambling the current service. Visible only if BISS-E is selected for
Scrambling. The key entered here is encrypted by the BISS Injected
ID found under Advanced/System/Base Unit.
The Setmode state of the Transport Stream. Read only parameter.
Sets the Setmode state of the Transport Stream. The options
available depends on the value set for MGP Mode under
Advanced/System/MGP Support.
The Bit Rate of the Transport Stream.
Off, Maximise video. Enables or disables Bit Rate tracking for the
current Transport Stream.
If set to true, it automatically re-enables the Transport Streams
when all the specified error conditions are cleared.
Never, Audio Lost, Video Lost, Any Upstream CRITICAL Alarm, Any
CRITICAL alarm. Disables the output when the set condition is met.
The Transport Stream can be set to be re-enabled at the Auto
Disable option.
DVB, ATSC
EN/LZT 790 0023/1 R16A