Ericsson AVP 1000 Reference Manual page 83

When configured in MPEG-1 Layer II 6 or 8 Channel Aligned Encoding, each pairing
is identified by the use of ISO_639_language descriptors. The languages are
encoded using two language codes per component as follows:
•
•
When adding PAA to an output Transport Stream service each audio component
that makes up the PAA must be manually added to the service before configuring
the components for PAA.
Configuration
To set up PAA or dual PAA audio streams for a service on the Service
Configuration page, proceed as follows:
Note: This procedure assumes that a service has already been created. If not, one
1. In the Inputs widget, select Audio 1- Audio 3 (for 6 channel aligned) or Audio 1
2. Drag the selected components to a service in the Outputs widget.
3. If you are setting up dual PAA encoding, repeat steps 1-2 for Audio 9 - Audio
4. In the Outputs widget, click on the audio component corresponding to Audio 1.
Note: If you click on Audio Stream 1 in the Inputs widget, the corresponding
5. In the Properties widget, click on the Input tab.
6. Set the Input Format to Uncompressed LPCM.
7. Set the Input Source to Embedded 1 (SDI 1).
EN/LZT 790 0023/1 R16A
First instance on Audio Module 1:
- aaa, aab for first dual mono
- aac, aad for second dual mono
- aae, aaf for third dual mono
- aag, aah for fourth dual mono
Second instance on Audio Module 2:
- bba, bbb for first dual mono
- bbc, bbd for second dual mono
- bbe, bbf for third dual mono
- bbg, bbh for fourth dual mono
must be created before continuing. See section 3.25.3.
- Audio 4 (for 8 channel aligned) by first selecting Audio 1, holding down the
Shift key, then clicking on Audio 3 (for 6 channel aligned) or Audio 4 (for 8
channel aligned).
11 (for 6 channel aligned) or Audio 9 - Audio 12 (for 8 channel aligned).
audio stream will be highlighted in grey in the Outputs widget.
Getting Started
3-41