Ericsson AVP 1000 Reference Manual page 212

Web GUI Control
Parameter Values
Modulation QPSK
16APSK
L
Modulation for TS2 QPSK, 8PSK
1,4
Pilots Off, On
1
Pilots for TS2 Off, On
NCR Stamping PID 0 - 8191
Symbol Mapping
Peak Power, Mean Power
Mode
PL Scrambling 0 to 26141
1,4
Sequence Number
Symbol Rate 1.000000 Msymbol/s to 45.000000 Msymbol/s
(standard)
0.132000 Msymbol/s to 66.000000 Msymbol/s
(with VOY/SWO/HSYM license - extended
range)
Roll-off Factor 5, 10, 15, 20, 25, 35 %
1 Applies to DVB-S2
2 Applies to DVB-DSNG
3 Applies to DVB-S
4 Applies to DVB-S2X
5.4.4.7.4 Satellite Modulator Output Configuration
The following parameters are available through the Advanced Setup tab of the
Device Configuration page under Slots > Slot <n> - Satellite Modulator Option
Card > Satellite Modulator > Output Parameters or on the Output Parameters
tab in the Properties widget of the Service Configuration page if one of the
Satellite Modulator Output Stream is selected in the Outputs widget. The same
parameters can be accessed through the Advanced/Satellite Modulator/Output
Parameters menu on the front panel.
Table 5.10 Satellite Modulator Output Configuration Parameters
Parameter Values
RF Carrier ID State On, Off
Output Select L-band, IF
Output State On (Reduced Power), On (Nominal Power),
Off
L-Band Output
Frequency Input Mode L-Band Frequency, Uplink Frequency
5-36
1,2,3,4 1,2,4
, 8PSK , 8PSK-L
1,4 4
, 16APSK-L , 32APSK
4 4 4
, 64APSK and 64APSK-L
1,2 2
, 16QAM , 16APSK
Description
4 2
,16QAM , The modulation mode and order used for the transmission.
1,4,
,32APSK-
1 1
, 32APSK Same as above for the 2nd Transport Stream in VCM mode.
Toggles the insertion of pilot symbols into the transmitted
signal on and off.
Same as above for the 2nd Transport Stream in VCM mode.
The PID used for packets transmitting Network Clock
Reference.
Specifies what to use for power normalization.
The sequence number used for physical layer scrambling.
The symbol rate used for modulation.
The roll-off factor of the filter used for pulse shaping
Description
Enables DVB-CID on the modulator output.
Specifies which output to use.
Turns the output of the Satellite Modulator on at the specified
power level or off. Note that to enable the output, the Transport
Stream through the satellite modulator output has to be set to
Online Setmode state.
The mode how the frequency is treated. For L-Band
Frequency the RF center frequency of the respective output is
directly entered. For Uplink Frequency, the RF center
frequency is calculated from the Uplink Frequency and the Up-
converter Frequency.
EN/LZT 790 0023/1 R16A