Ce-X Vcm - Ericsson AVP 1000 Reference Manual

The following parameters are available in Properties widget on the Service
Configuration page when a PCR Stream is selected in the Outputs widget. The
same parameters can be accessed through the Output/<output name>/Transport
Stream ID: <n>/Service List/<service name>/Component List/Slot <m> Video 1
PCR stream on PID <n> menu on the front panel.
Table 5.47 PCR Stream Configuration Parameters
Parameter
PID
Bit Rate Weighting
5.5.3.3

CE-x VCM

5.5.3.3.1 Video and VBI Stream Configuration
Video Input and Pre-Processing
The following parameters are available on the Input tab of the Properties widget on
the Service Configuration page when a video component is selected in the
Outputs widget. The same parameters can be accessed through the
Advanced/CE-x/Video/Video1/Input menu on the front panel.
Table 5.48 Video Input and Pre-Processing Parameters
Parameter Values
Video Input Lock Yes, No
Source SDI
Bars
Black
Moving Object
Slate
Off, Auto Detect and Report, Auto Detect and
Input Detection
Configure Video Profile Only, Auto Detect and
Restore Saved Config
Detected Video Not Detected, SD 567i25, SD 480i29.97, HD
Standard 720p50, HD 720p59.94, HD 1080i25, HD
1080i29.97
Video Input Format SD 567i25, SD 480i29.97, HD 720p50, HD
720p59.94, HD 1080i25, HD 1080i29.97
EN/LZT 790 0023/1 R16A
Values
16 - 8190
Fixed
Description
The packet identifier assigned to packets carrying the
program clock reference values.
Not relevant for the PCR component. Read only
parameter.
Description
Shows whether there is a video lock to the format specified
through the parameters below. Read only parameter.
The video will be sourced from the SDI/HD-SDI input on
the rear panel.
An internally generated color bars test pattern will be used
as the video source.
An internally generated black test pattern will be used as
the video source.
An internally generated moving object test pattern will be
used as the video source.
A slate file uploaded by the user will be used as the video
source.
Controls whether the format of the SDI input shall be
automatically detected or what actions to take if a change
is detected in the Input Video Format.
The detected video standard if Input Detection is set to
other than Off. If the format is not detected or Input
Detection is set to Off, it is set to Not Detected. Read only
parameter.
Defines the expected video format on the SDI input or the
video format used for encoding the test patterns. A change
in the Video Input Format might result in a change in the
Video Profile used for encoding. As from the current
release down-conversion is supported, SD profiles can be
selected for HD input formats.
Web GUI Control
5-75