Ericsson AVP 1000 Reference Manual page 54

Getting Started
Ethernet Data Port Parameters
The data Ethernet ports Ge 1 and Ge 2 are bonded together, as are Ge 3 and Ge 4.
Each port of a pair transmits the same IP traffic. If the IP address, or subnet mask of
a secondary port is set to 0.0.0.0, then it will be assumed that it is operating in a
mirrored redundancy configuration with the primary port, and therefore has the same
IP address and subnet mask.
VLAN Tagging
VLAN tagging is supported on the Data Output interfaces. To configure VLAN, browse to
Device Configuration > Advanced Setup and select Vlan Group in the appropriate output
under the Vlan Tags folder. Alternatively, you can also use the front panel to set up VLANs.
The settings can be found under Advanced/System/Base Unit/Vlan Tags.
The data Ethernet ports are configured by the parameters listed in the following
table.
Table 3.3 Ethernet Data Port Parameters
Parameter Values
Network Mode Same Network [default]
Different Network
IP Redundancy Mode Active-Active
Active-Standby
Active Interface Primary, Secondary
Line Speed Auto
100 Mbps
1 Gbps
Duplex Mode Auto [default]
Full Duplex
Half Duplex
Default Virtual MAC
aa:bb:cc:dd:ee:ff
Address
IP Address aaa.bbb.ccc.ddd
Subnet Mask 0.0.0.0 [default]
aaa.bbb.ccc.ddd
Default Gateway 0.0.0.0 [default]
aaa.bbb.ccc.ddd
IGMP mode selection IGMP v3
3-12
Description
The interface pair is on the same
subnet.
The interface pair is on different
subnet.
The same traffic is present on both
interfaces all the time.
The secondary interface is active
only if the primary is down.
The currently active interface
The connection speed
Auto negotiate the mode
Simultaneously transmit and receive
Transmit and receive in a time
division manner
The virtual MAC address of the Gex
interface.
Virtaul IP address of the data
interface group
Subnet mask for the data interface
group
No defined gateway
Gateway address for packets
outside the defined subnet
Uses version 3 of the IGMP protocol
Comments
If Network Mode is set to Different
Network then Active-Active is set and
becomes read only.
Read only parameter
Read only parameter
Must be unique
Will be used as source address for
multicast output.
EN/LZT 790 0023/1 R16A