Ericsson AVP 1000 Reference Manual page 104

Getting Started
4. Only the first service in a Transport Stream is available in the Simplified View.
5. The input monitor shows the status of the components in the first service of the
6. When multiple outputs are available and configured, the output for which the
7. When outputs are mirrored the common configurable parameters of the mirrored
8. When the outputs are independent and have been configured with different
9. A Remux service must NOT be the first service in the output TS as:
10. A Pass-thru transport stream is not recognised as a supported output
11. Current alarm status is reported on the Simplified View but alarm masking needs
12. A browser refresh may be needed to update the display to show some changes
13. Some unlicensed features are displayed but an attempt to configure the feature
14. Limited Video Profiles. The Simplified View only supports configuring MPEG-2
3-62
Additional services may be configured, but need to be accessed using the
Advanced View.
main output.
Simplified View supports configuration of TS parameters is determined in the
following order:
- Satmod – if fitted and configured.
- IP – if fitted and configured.
- ASI – if configured.
This cannot be modified.
output will be read only (so bit rate and encryption can only be set for the main
output). There is the ability to set each output ON or OFF.
BISS keys the Advanced View must be used to enable/disable encryption,
otherwise the key will be replaced with BISS key 1.
- The Simplified View will reject a Remux service as a non-supported
configuration. Ensure that the first service contains components encoded in
the box.
- A Remux service can be the second service, but there is no visibility or
access to this service from the Simplified View.
configuration for the Simplified View. The advanced view needs to be used for
this configuration.
to be performed using the Advanced View.
made using other interfaces (e.g. via front panel). This applies to both Simplified
View and the Advanced View.
will result in an error message pop-up stating not enough licenses and the
configuration will be rejected.
Main profile (main level for SD or high level for HD) and H.264 High (level 3.1 for
SD or level 4.1 for HD) profiles. This means:
- It is not possible to configure SD H264 Main Level 3.0, SD H264 High Level
3.0 or HD H264 Main level 4.0, which are available on the Advanced View.
EN/LZT 790 0023/1 R16A