Rep 9.3 Terminal Assembly - Xerox WorkCentre 4150 Service Manual

3. Remove the CRUM PWB, Figure 2.
Figure 2 PWB removal
Replacement
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 9.2, REP 9.3

REP 9.3 Terminal Assembly

Parts List on PL 4.15
1
Removal
Remove the CRUM PWB.
Switch off the electricity to the machine. Disconnect the power cord from the customer
2
supply while performing tasks that do not need electricity. Electricity can cause death or
Disconnect the
injury. Moving parts can cause injury.
connector.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the exit tray assembly, PL 28.10 Item 1 or finisher, REP 12.1.
2. Remove the paper exit cover, PL 28.10 Item 4.
3. Disconnect CON1 on the HVPS.
4. Release the harness from the cable tie and cable clamp.
5. Remove the main drive assembly, REP 4.1.
6. Remove the terminal assembly, Figure 1.
2
Remove 4 screws marked A.
Replacement
Replacement is the reverse of the removal procedure.
September 2006
4-42
WARNING
WARNING
CAUTION
3
Release the harness,
then remove the terminal
assembly.
1
Remove 1 screw.
Figure 1 Terminal assembly removal
WorkCentre 4150