Configuring The Base Station - Datalogic Gryphon I GM440 Series Product Reference Manual

Setup
Figure 5. Other Interface Connections
RF Models
The power supply connects directly to the base (not on the cable's jack) for
all configurations. For all interfaces (except RS-232) a power supply is rec-
ommended but not necessary, because the base can be powered from the
Host. When the base is powered from the Host, select a slow charge rate.
Setting Up the Reader
Follow the steps below to connect and get your reader up and communicat-
ing with its host.
1. Configure the Base Station starting on this page.
2. Charge the Batteries (see page 9).
3. Link to the Base Station (see page 10.
4. Select the Interface Type (see page 11).
5. Configure the Reader starting on page
12
or...
Specific cables are required for connection to different hosts. The con-
nectors illustrated above are examples only. Actual connectors may
vary from those illustrated, but the steps to connect the reader remain
the same.
tings needed).
Star Models and Frequency
The Gryphon GM4400-xx-433 must be used with BC40x0-xx-433 base sta-
tion models.
The Gryphon GM4401-xx-910 must be used with BC40x1-xx-910 base sta-
tion models.
or...
21 (optional, depends on set-
Gryphon™ I GD44XX/GBT4400/GM440X