Intercharacter Delay; Intercode Delay - Datalogic Gryphon I GFE4500 Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and
the beginning of the next. The delay can be set within a range of zero (0) to 990 millisec-
onds in 10ms increments. A setting of zero specifies no delay. See "
page 227
$CR2IC00
Select Intercharacter Delay Setting
$CR2IC
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The select-
able range for this feature is from 0 to 99 seconds. See "
more detailed programming instructions
Set Intercode Delay
$CKBID
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
56
GRYPHON™ GFS4500
for more detailed programming instructions.

00 = No Intercharacter Delay

00 = No Intercode Delay
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Keypad representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
CANCEL
Intercode Delay" on page 227
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix E, Keypad
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
CANCEL
KEYBOARD INTERFACE
Intercode Delay" on
Appendix E,
for
represent-