Wedge Quiet Interval; Intercode Delay - Datalogic QuickScan I QD24 Series Product Reference Manual

Wedge Quiet Interval

Specifies amount of time to look for keyboard activity before scanner breaks keyboard connection in order to
transmit data to host. The selectable range for this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments
of ten milliseconds. See
$CKBQI
Set Wedge Quiet Interval
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable range for this feature is
from 0 to 99 seconds.
See page 216 in "References" for detailed information and examples for setting this feature.
$CKBID
Set Intercode Delay
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Product Reference Guide
page 214 in "References" for detailed information and examples for setting this feature.
DEFAULT
DEFAULT
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad
ter(s). End by scanning the ENTER/EXIT bar code again.
~
0A = Quiet Interval is
100 milliseconds
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad
ter(s). End by scanning the ENTER/EXIT bar code again.
~
00 = No Wedge Intercode Delay
Enter/Exit Programming Mode
representing your desired charac-
CANCEL
representing your desired charac-
CANCEL
39