Optics; Replacing The Integrator Rod - Christie Crimson Series Service Manual

Optics

Learn how to replace the light source, mirrors, and other optical components.
The projector must be powered off and all components must be re-installed before powering on the
projector for doing any optical alignment.

Replacing the integrator rod

The integrator rod captures the light source and combines it into a uniform rectangular light source for
the light engine.
Wear gloves when handling the integrator rod assembly.
1. Remove the top cover (on page 42).
2. Remove the electronics-side cover (on page 43).
3. Remove the four screws securing the integrator housing collar and remove it.
4. Loosen the integrator rotate-focus lockscrew.
5. Align the knob with the top indicator and slide the knob upwards to its limit.
Crimson Service Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102733-02 Rev. 1 (01-2020)
Copyright 2020 Christie Digital Systems USA, Inc. All rights reserved.
©
77