Introduction; Site Requirements; Physical Operating Environment; Power Connection - Christie Roadie 4K35 Service Manual

Hide thumbs Also See for Roadie 4K35:

Table of Contents

Introduction

This document provides technical information for assisting Christie qualified technicians in the

servicing of the Roadie 4K35 and 4K45 projectors .

Every effort has been made to make sure the information in this document is accurate and complete.

However, due to continuing research all information is subject to change without notice. Christie

assumes no responsibility for omissions or inaccuracies.

To safely install and operate the projector, the installation location must have restricted access for

authorized personnel only and meet these minimum requirements.

Provides specifications for the operating environment.

•

Maximum ambient temperature (operating) 35°C (95°F)

•

Minimum ambient temperature (operating) 10°C (50°F)

Learn the requirements for permanently wired installations or power cord connections.

•

Single phase 10A IEC320C14 (lamp power supply to projector head)

Single phase 15A (North America)/10A (all other regions) power cord (projector head to AC

mains). The latter cord is provided for installations where the projector head is remotely

lcoated from the lamp power supply (LPS) and must be powered directly from the AC mains

instead of the LPS.

•

Terminal block, electrician hard-wired at the projector headlamp power supply (LPS).

Three-phase, 39A 200-230VAC + Earth (North America and Japan)

Three-phase, 26A 380-415VAC + Neutral + Earth (regions outside North America and Japan)

•

This product can be connected to an IT power distribution system.

Roadie 4K35 and 4K45 Service Manual

020-101694-03 Rev. 1 (01-2016)

Table of Contents

Roadie 4k45