Table of Contents
Advertisement
Projector components
Learn where to find the components of the projector.
ID
Item
A
Touch panel controller (TPC)
B
LED status indicators
C
Manual douser override
D
Lamp door and lamps
E
Low profile extractor
F
Radiator access door panel
G
Shroud (optional)
H
Projection lens
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Description
A touch-sensitive screen used to control and monitor operation. See
Touch panel controller.
LED color and blinking rates (located in both back corners of the
projector) provide information about the status of the projector. See
Projector LED status indicators.
Closing the douser rotates a shutter blade in front of the lamp and
reduces the lamp power to its minimum. The override is for emergency
use only.
The lamp door provides access to the lamp compartment and must
remain closed and locked for normal operation. Lamp replacement should
only be performed by qualified technicians. See Accessories.
Extracts heated air from the lamp compartment out the back of the
projector. The Roadie Ducted Exhaust kit (not shown) P/N: 113-107109-
xx is available to duct hot air away from the projector. See Accessories.
The radiator door provides access to the radiator and liquid cooling
compartment and must remain closed during normal operation.
Covers the motorized lens mount assembly (two-pieces).
A variety of lenses can be used with the Roadie 4K35 and 4K45. See
Accessories.
Introduction
8
Advertisement
Table of Contents
