Replacing The Shutter Assembly; Replacing The Light Engine Assembly - Christie CP2208-LP Service Manual

22. Adjust the fold mirror for the final time.
23. Tighten the fold mirror set screws.

Replacing the shutter assembly

The shutter assembly is mounted directly on the light engine. It can be removed with the light engine
or removed by itself
Estimated time to replace: 10 minutes.
1. Remove the lens (on page 78).
2. Remove the top skin (on page 32).
3. Remove the high security and light engine covers (on page 40).
4. Disconnect the shutter assembly harness from inline connector.
5. Release the one #1 Phillips self retaining screw from the light dump and remove it.
6. Remove the two 3 mm hex head screws securing shutter assembly bracket to the light engine.
7. Angle the shutter assembly up and out.
8. To replace the shutter assembly, complete these steps in reverse order.

Replacing the light engine assembly

The light engine modulates incoming light from the light source to create an image, which is projected
to the screen.
Estimated time to replace: 25 minutes.
1. Turn the projector off and disconnect it from AC power.
2. Remove the lens (on page 78).
3. Remove the top skin (on page 32).
4. Remove the high security and light engine covers (on page 40).
5. Remove the light engine blower assembly.
6. Loosen the captive screw securing the light dump and remove it.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Optics
76