Table of Contents
Advertisement
Servicing live equipment
Only Christie accredited technicians who are knowledgeable about the hazards associated with
hazardous voltage, ultraviolet exposure, and high temperatures are authorized to assemble, install,
and service Christie equipment.
To make sure you remain safe when servicing energized (live) Christie equipment:
•
Locate the main AC power shut off prior to servicing the equipment. This will allow you to turn
the power off quickly in an emergency.
•
Disconnect the projector from the communication and management network so it cannot
receive commands to turn the lamp on, open the douser, and move the lens.
•
Familiarize yourself with all potential safety hazards prior to servicing the equipment. This
includes, but is not limited to, the location and accessibility of hazardous voltages.
•
Read and understand all written procedures prior to commencing a service procedure.
•
Understand and follow all local safety codes and requirements when servicing energized (live)
equipment.
•
Perform equipment service in a location free of obstructions and other hazards. For example,
you must have an unobstructed view of the area being serviced.
Wear personal protective equipment (PPE) clothing appropriate to the service you are performing. This
includes, but is not limited to, protective (electrically insulated) footwear, safety glasses, and gloves
rated for the working voltage of the equipment you are servicing.
Safety and warning guidelines
Read all safety and warning guidelines before installing or operating the projector.
This projector must be operated in an environment that meets the operating range specification. Use
only the attachments and/or accessories recommended by Christie. Use of others may result in the
risk of fire, shock, or personal injury.
Warning! Failure to comply with the following could result in death or serious injury.
•
Do not look directly into the lens or at the lamp. The extremely high brightness can cause
permanent eye damage.
•
EXTREME BRIGHTNESS! When accessing a restricted access location for product service or
maintenance, avoid exposure to the product beam path by turning the product power off and
disconnecting the product from AC power, or by shuttering the lamp to avoid emissions from the
front aperature.
•
FIRE HAZARD! Keep hands, clothes, and all combustible material away from the concentrated
light beam of the lamp.
•
UV EXPOSURE! Protective UV safety glasses with side shields and Christie approved protective
safety clothing must be worn when performing optical adjustments or servicing the product.
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Service guidelines
12
Advertisement
Table of Contents
