Table of Contents
Advertisement
Troubleshooting
The following topics cover common projector issues and their solutions.
If an issue cannot be resolved, contact a Christie qualified technician.
Projector does not power on
The projector is connected to AC power but does not power on.
Resolution
•
Make sure that all three circuit breakers on the lamp power supply (LPS) are turned on.
•
Make sure the projector circuit breaker is set to the on position.
•
Check the status LEDs on the rear corners of the projector for a fault condition. A flashing red
LED indicates an alarm or warning preset with the projector and a problem that must be
addressed.
•
Use the touch panel controller (TPC) status menu to troubleshoot further.
Lamp does not ignite
The projector is powered on but the lamp does not ignite.
Resolution
•
Make sure all three breakers on the lamp power supply (LPS) are set to their on positions.
•
Check and correct all interlock failures.
•
Check the lamp power supply communication connections and restart the projector.
•
Verify that the lamp has been installed and connected properly. Verify the condition of the
lamp and that is not blackened or otherwise damaged.
•
Verify the number of hours the lamp has operated. A lamp nearing the end of its operational
life should be replaced.
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
31
Advertisement
Table of Contents
