Table of Contents
Advertisement
Caution! Failure to comply with the following could result in minor or moderate injury.
•
SHOCK HAZARD! Disconnect the product from AC before moving, servicing, cleaning, removing
components, or opening any enclosure.
•
Christie products must be installed and serviced by Christie qualified technicians.
•
TRIP OR FIRE HAZARD! Position all cables where they cannot contact hot surfaces, be pulled, be
tripped over, or damaged by persons walking on or objects rolling over the cables.
•
The American Conference of Governmental Industrial Hygienists (ACGIH) recommends
occupational UV exposure for an 8-hour day to be less than 0.1 microwatts per square
centimeters of effective UV radiation. A workplace evaluation is advised to assure employees are
not exposed to cumulative radiation levels exceeding the government guidelines for your area.
Be aware that some medications are known to increase sensitivity to UV radiation.
Notice. Failure to comply with the following may result in property damage.
•
SHOCK HAZARD! All harnessing must be properly routed and secured as originally installed,
especially in high voltage areas.
•
FIRE HAZARD! Do not use a power cord or harness that appears damaged.
AC/power precautions
To correctly install this projector, a certified electrician must install a permanent three-phase
connection to the lamp power supply (LPS). The LPS projector outlet supplies power to the projector
head. Operate the projector at the recommended voltage.
Danger! Failure to comply with the following results in death or serious injury.
•
Disconnect projector from AC before opening any enclosure.
Warning! Failure to comply with the following could result in death or serious injury.
•
FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
•
SHOCK HAZARD! Only use the AC power cord provided with the product or recommended by
Christie.
•
FIRE OR SHOCK HAZARD! Do not overload power outlets and extension cords.
•
FIRE HAZARD! Do not use a power cord that appears damaged.
Lamp precautions
Lamps used in the projector are under high pressure and must be handled with caution. Lamps can
explode and cause serious personal injury if dropped or mishandled.
Danger! Failure to comply with the following results in death or serious injury.
•
Do not open the lamp door while the lamp is on.
•
EXPLOSION HAZARD! Allow sufficient time for the lamp to cool down before powering down the
product, disconnecting it from AC, and opening the lamp door.
•
Christie products must be installed and serviced by Christie qualified technicians.
•
EXPLOSION HAZARD! Always wear manufacturer approved protective safety clothing (gloves,
jacket, face shield) whenever the lamp door is open or when handling the lamp. Any local or
federal specifications take precedence over Christie's protective clothing recommendations.
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Service guidelines
13
Advertisement
Table of Contents
