Replacing The Bayonet Lock Assembly - Christie 4K40-RGB Series Service Manual

6. With a flathead screwdriver, adjust the plunger until the motor assembly is free.
7. Disconnect the harness to the affected motor.
8. Replace the affected motor.
9. To re-install, repeat these steps in reverse order.

Replacing the bayonet lock assembly

The bayonet lock assembly is the lock used to keep the lens secure.
1. Remove the front cover (on page 35).
2. Disconnect the LCBP harness, leaving the circuit board affixed to the front bayonet plate.
3. Remove the three M4 screws securing the front bayonet plate.
4. Pull the front bayonet plate off of the pins, which locate it to the rear plate.
The LCBP and the bayonet lock come with the front plate.
4K40-RGB Series Service Guide–D4K40-RGB, Roadie 4K40-RGB, Mirage 4K40-RGB
020-102960-02 Rev. 1 (12-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Lens mount components
41