Table of Contents
Advertisement
Caution! Failure to comply with the following could result in minor or moderate injury.
•
a) Disconnect J34 from the EVB2 board and release the harness from the routing clips.
b) Remove the four screws from the AC knock-out plate.
c) Remove the two screws securing the front plate to the baseplate, located on the inside
of the light engine compartment.
d) Remove the eight screws securing the front plate to the frame.
7. To re-install, follow these steps in reverse order.
Filtration
Filters help to keep dust and other foreign materials out of the projector.
Notice. Failure to comply with the following may result in property damage.
•
Do not operate the product without the filter installed.
•
Use only high efficiency Christie approved filters.
•
Do not reuse an old air filter.
Removing the light engine air filter
The light engine filter is located on the lens side of the projector behind the air filter cover.
Estimated replacement time: 1 minutes
1. Remove the two screws securing the air filter cover and release the two tabs.
2. Lift up the cover enough for the bottom tabs to clear the frame and remove.
3. Slide the air filter out from behind the air filter cover.
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
A minimum of two people or appropriately rated lift equipment is required to safely lift,
install, or move the product.
Parts and module replacement
45
Advertisement
Table of Contents
