Replacing The Centrifugal Fan Interface Board; Power Supplies; Replacing The Igniter - Christie Roadie 4K35 Service Manual

6. Remove the rod ball joint by unscrewing it from the lamp adjuster assembly.
7. Loosen the four captive screws securing the lamp adjust to the baseplate.
8. Remove the lamp adjuster assembly through the lamp door.
9. To complete the installation, repeat these steps in reverse order.
10. Perform a lamp calibration.

Replacing the centrifugal fan interface board

Estimated replacement time: 5 minutes
1. Remove the rear lens-side cover (on page 43).
2. Disconnect the cable connections P1, P3,a nd P4.
3. Remove the four hex head screws securing the centrifugal fan interface board (CFIB).
4. Remove the CFIB.
5. To install the CFIB, repeat these steps in reverse order.

Power supplies

Learn how to replace power related components.

Replacing the igniter

Estimated replacement time: 35 minutes + 10 minute calibration
When installing the positive and negative igniter harness leads to the igniter, do not over tighten the
M10 screw to avoid bending the metal connection plates attached to the igniter.
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Parts and module replacement
73