Shutting Down For Maintenance; Projector Covers; Removing The Touch Panel Controller - Christie Roadie 4K35 Service Manual

Hide thumbs Also See for Roadie 4K35:

Table of Contents

Shutting down for maintenance

Always perform these steps before beginning any inspection or maintenance procedures on the

projector.

1. If the projector is operating, turn it off and allow it to cool for a minimum of 10 minutes.

2. Set the projector breaker switch to the off position.

3. Set the lamp power supply's three breaker switches to the off positions.

4. Disconnect the projector from AC power.

Learn how to remove the covers and touch panel controller (TPC) of the projector.

The touch panel controller (TPC) is a touch-sensitive screen used to control the projector, manage

sources, adjust the display, and view status information.

Estimated replacement time: 2 minutes

1. Remove the TPC tether (if installed) by removing the two screws from the ball joint on the

TPC and the ball joint on the projector which the tether is fastened to.

2. Disconnect the TPC harness from the connector on the projector's back cover.

Disconnecting the TPC harness resets the TPC.

3. Loosen the TPC mounting arm slightly to remove the TPC assembly from the ball mount at

the back of the projector.

Roadie 4K35 and 4K45 Service Manual

020-101694-03 Rev. 1 (01-2016)

Parts and module replacement

Table of Contents

Roadie 4k45