Table of Contents
Advertisement
Optics
Learn how to replace lamps, mirrors, and other optical components.
Removing the lamp
Estimated replacement time: 5 minutes + 10 minute calibration
Danger! Failure to comply with the following results in death or serious injury.
•
Christie products must be installed and serviced by Christie qualified technicians.
•
EXPLOSION HAZARD! Always wear manufacturer approved protective safety clothing (gloves,
jacket, face shield) whenever the lamp door is open or when handling the lamp. Any local or
federal specifications take precedence over Christie's protective clothing recommendations.
•
EXPLOSION HAZARD! Allow sufficient time for the lamp to cool down before powering down the
product, disconnecting it from AC, and opening the lamp door.
Caution! Failure to comply with the following could result in minor or moderate injury.
•
EXPLOSION HAZARD! Handle a lamp by the cathode and anode end shafts only. Do not handle
the lamp by the glass.
Warning! Failure to comply with the following could result in death or serious injury.
•
EXPLOSION HAZARD! Lamps and bare bulbs, even when packaged, may explode if dropped or
mishandled.
•
Christie products must be installed and serviced by Christie qualified technicians.
1. Remove the lamp door (on page 42).
2. Depress the two clips securing the front lamp duct and remove.
3. Loosen the set screw securing the anode (+) lamp connection.
4. Loosen the set screw securing the cathode (-) lamp connection.
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Parts and module replacement
60
Advertisement
Table of Contents
