Fisher FIELDVUE DVC6200f Instruction Manual page 93

Instruction Manual
D103412X012
Table 4‐14. Transducer Block Parameter Definitions (Continued)
Label
PARAMETER_NAME
PRESSURE_DIFF
Pressure Differential Status
STATUS
Pressure Differential
VALUE
PWA Simulate
PWA_SIMULATE
Grant Deny
GRANT_DENY
GRANT
DENY
Travel Pressure Control
TVL_PRESS_CONTROL
Travel/Pressure Select
TVL_PRESS_SELECT
Travel/Pressure State
TVL_PRESS_STATE
Index RO /
Mode
Number RW
38
38.1 RO N/A
38.2 RO N/A
RO or 1=Simulate Off
39 ALL
RW* 2=Simulate Enabled
40
40.1 RW ALL
0: Program
1: Tune
2: Alarm
3: Local
40.2 RW ALL
41
1=Travel
2=Pressure
41.1 RW ALL
3=TVL/PRESS Auto Recv
4=TVL/PRESS Man Recv
1=Travel
41.2 RO N/A
2=Pressure
Range Initial Value
1=Simulate Off
all bits cleared
all bits cleared
1=Travel
-Continued-
Detailed Setup—Transducer Block
Protect
Description
Category
Data Type: DS‐65
STATUS indicates the validity of
N/A VALUE. VALUE is the difference
between PRESSURE_A and
PRESSURE_B, controls AI channel 8.
N/A
Data Type: Enum (Uint8)
When this is set to 2 all the alert
ACTIVE parameters can be written,
except for INST_ALERTS_ACTIVE.
SHUTDOWN_ALERT_ACTIVE. This
allows alerts to be simulated for
ALL testing with hosts. NOTE: only
ACTIVE parameters are affected by
this. * PWA Simulate is RW only if a
jumper is installed across the Aux
Terminal. If no jumpered is installed
across the Aux Terminal, PWA
Simulate is RO.
Data Type: DS‐50
Options for controlling access of
NONE
host computer and local control
panels to operating, tuning, and
alarm parameters of the block. Has
no effect on the DVC6200f.
NONE
GRANT: 0=N/A, 1= granted
DENY: 0=N/A, 1= denied
Data Type: Enum (Uint8)
SETUP Selects whether travel sensor or port
A pressure is used for feedback.
Data Type: Enum (Uint8)
Indicates which sensor is used for
N/A
feedback
July 2013
91