Fisher FIELDVUE DVC6200f Instruction Manual page 91

Instruction Manual
D103412X012
Table 4‐14. Transducer Block Parameter Definitions (Continued)
Label
PARAMETER_NAME
Travel Cutoff Hi
FINAL_VALUE_CUTOFF_HI
Travel Cutoff Lo
FINAL_VALUE_CUTOFF_LO
FINAL_POSITION_VALUE
Travel Status (Decharacterized)
STATUS
Travel (Decharacterized)
VALUE
Travel Proportional Gain
SERVO_GAIN
Travel Integral Gain
SERVO_RESET
Travel Velocity Gain
SERVO_RATE
Actuator Fail Action
ACT_FAIL_ACTION
Actuator Manufacturer
ACT_MAN_ID
Actuator Model Number
ACT_MODEL_NUM
Actuator Serial Number
ACT_SN
Valve Manufacturer
VALVE_MAN_ID
Valve Model Number
VALVE_MODEL_NUM
Valve Serial Number
VALVE_SN
Valve Style
VALVE_TYPE
Calibration Location
XD_CAL_LOC
Calibration Date
XD_CAL_DATE
Calibration Person
XD_CAL_WHO
Index RO /
Mode
Number RW
MAN
15 RW -25 to 125
OOS
MAN
16 RW -25 to 125
OOS
17
17.1 RO N/A
17.2 RO N/A -25 to 125%
MAN
> = 0
18 RW
OOS
> = 0 , = 0 causes wind
MAN
19 RW
OOS
down
MAN
> = 0
20 RW
OOS
0=Uninitialized
MAN
21 RW 1=Self Closing
OOS
2=Self Opening
22 RW ALL
23 RW ALL
24 RW ALL
25 RW ALL
26 RW ALL
27 RW ALL
1=sliding-stem
28 RW ALL
2=Rotary
29 RW ALL
30 RW ALL
31 RW ALL
Range Initial Value
99.5
0.5
N/A
4.4
9.4
3.0
1=
Self Closing
0x5100
Null
Null
0x5100
Null
Null
1=sliding-stem
Null
Uninitialized
Null
-Continued-
Detailed Setup—Transducer Block
Protect
Description
Category
Data Type: Float
When the servo goes above this % of
span, the stem position goes to the
SETUP
upper limit. Cutoffs are OFF when
Low is at -25% and high is at +125%.
Must be > low cutoff + .625%.
Data Type: Float
When the servo goes below this % of
span, the stem position goes to the
SETUP
lower limit. Cutoffs are OFF when
Low is at -25% and high is at +125%.
Must be < hi cutoff - .625%.
Data Type: DS‐65
In Travel Control: Valve travel in %,
decharacterized to correlate with
Setpoint (FINAL_VALUE [13]).
N/A In Pressure Control: Implied valve
travel as a % of pressure range,
decharacterized to correlate with
N/A Setpoint (FINAL_VALUE [13]).
Controls AI channel 3.
Data Type: Float
SETUP
Travel Control Only. Gain of servo.
Data Type: Float
SETUP Travel Control Only. If set to 0, will
cause integrator to wind down.
Data Type: Float
SETUP
Travel Control Only. Rate of servo.
Data Type: Enum (Uint8)
SETUP Action performed by actuator in the
event of air pressure.
Data Type: Uint32
SETUP The actuator manufacturer
identification number.
Data Type: Visible String
SETUP
Model number of actuator.
Data Type: Visible String
SETUP
Serial number of actuator.
Data Type: Uint32
The valve manufacturer
SETUP
identification number.
Data Type: Visible String
SETUP
The valve model number.
Data Type: Visible String
SETUP
The valve serial number.
Data Type: Enum (Uint8)
SETUP
Selects Rotary or sliding-stem.
Data Type: Visible String
CAL
Where device was last calibrated.
Data Type: Date
CAL
Date of last calibration.
Data Type: Visible String
CAL Name of person performing last
calibration.
July 2013
89