Methods; Accessing Parameters - Fisher FIELDVUE DVC6200f Instruction Manual

Operating with a DeltaV System
July 2013

Methods

Transducer Block
The following methods are accessed via the transducer block: Device Setup, Auto Travel Calibration, Manual Travel
Calibration, Supply Sensor Calibration, Output A Sensor Calibration, Output B Sensor Calibration, Travel Sensor Adjust,
Stroke Valve, Performance Tuner, Stabilize/Optimize, and Relay Adjust.
Refer to figures F‐1, F‐2, and F‐3 and the following steps to access these methods.
1. Start DeltaV Explorer by selecting DeltaV Explorer from the Start menu.
2. Locate the the digital valve controller icon in the All Containers pane (the left panel) and right‐click once on the
digital valve controller icon or name.
3. Locate Open with AMS Device Manager in the context menu and left‐click to bring up the Device Connection View.
4. Navigate to the digital valve controller icon or name as shown in figure F‐2 and left‐click.
5. Locate Methods in the Actions menu, as shown in figure F‐3 and right‐click once.
6. Select the desired method from the the Actions menu and left‐click to start the method.
Resource Block
The Restart Options method and the DD Information method are available via the resource block. Refer to figure F‐3
and the following steps to access these methods.
1. Start DeltaV Explorer by selecting DeltaV Explorer from the Start menu.
2. Locate the digital valve controller icon in the All Containers pane (the left panel) and right‐click once on the digital
valve controller icon or name.
3. Locate Open with AMS Device Manager in the context menu and left‐click to bring up the Device Connection View.
4. Navigate to the digital valve controller icon or name as shown in figure F‐2 and left‐click.
5. Locate Methods in the Actions menu, as shown in figure F‐3 and right‐click once.
6. Select the desired method from the the Actions menu and left‐click to start the method.

Accessing Parameters

Transducer Block
For detailed information on the parameters that are changed via the transducer block, refer to the Detailed Setup
section of this manual. Refer to figures F‐2, F‐3, and F‐4 for information on accessing transducer block parameters.
1. Start DeltaV Explorer by selecting DeltaV Explorer from the Start menu.
2. Locate the digital valve controller icon in the All Containers pane and right‐click once on the digital valve controller
icon or name.
3. Locate Open with AMS Device Manager in the context menu and left‐click to bring up the Device Connection View.
4. Navigate to the digital valve controller icon or name as shown in figure F‐2 and left‐click.
5. Locate Configure/Setup in the Actions menu (see figure F‐3) and left‐click to access Configuration and Setup
parameters.
6. Left‐click on Digital Valve Controller (TRANSDUCER) to access the transducer block parameters. Refer to table F‐1
for the transducer block configuration menu.
312
Instruction Manual
D103412X012