Wiring And Electrical Connections; Connecting Fieldbus Wiring - Fisher FIELDVUE DVC6200f Instruction Manual

Instruction Manual
D103412X012

Wiring and Electrical Connections

Connecting Fieldbus Wiring

The digital valve controller is normally powered over the bus from a fieldbus power supply. Refer to the site planning
guide for proper wire types, termination, length, etc. for a fieldbus loop.
Note
As shipped from the factory, the DVC6200f digital valve controller will not move the valve when power is applied to the
instrument. To avoid the valve going to an unknown position when power is applied, the unit is shipped from the factory with the
transducer block mode Out of Service. See the Basic Setup section for information on setup and calibration and placing the
instrument in service.
WARNING
To avoid personal injury resulting from electrical shock, do not exceed the maximum input voltage specified in table 1‐1 of
this quick start guide, or on the product nameplate. If the input voltage specified differs, do not exceed the lowest specified
maximum input voltage.
WARNING
Select wiring and/or cable glands that are rated for the environment of use (such as hazardous area, ingress protection and
temperature). Failure to use properly rated wiring and/or cable glands can result in personal injury or property damage
from fire or explosion.
Wiring connections must be in accordance with local, regional, and national codes for any given hazardous area approval.
Failure to follow the local, regional, and national codes could result in personal injury or property damage from fire or
explosion
Personal injury or property damage caused by fire or explosion may occur if this connection is attempted in a potentially
explosive atmosphere or in an area that has been classified as hazardous. Confirm that area classification and atmosphere
conditions permit the safe removal of the terminal box cover before proceeding.
Installation
July 2013
31