Detailed Setup—Transducer Block
July 2013
Table 4‐14. Transducer Block Parameter Definitions (Continued)
Label
PARAMETER_NAME
TRAVEL_CAL_RUN
Travel Calibration Command
TVL_CAL_CMD
Travel Calibration Prog
TVL_CAL_PROG
Travel Calibration Status
TVL_CAL_STATUS
Reserved
TVL_CAL_RESERVED
94
Index
RO /
Mode
Number
RW
45
1: Operating
2: Autocalibrate
3: Not Used by DVC6200f
4: Mark Full Open
5: Mark Full Closed
6: Manual Calibrate Final
7: Abort
8: Clear Cal Status
9: Manual Calibrate Init
10: Manual Calibrate
Restore
11: Reset Travel Sensor
Error
45.1
RW
MAN
12: Reserved
13: Execute Performance
Tuner
14: Execute Performance
Tuner (Graphite Packing)
16: Execute Performance
Tuner (Booster)
17: Execute Performance
Tuner (Graphite Packing
and Booster)
19: Autocalibration, Set
Filter
20: Autocalibrate
Extended, Set Filter
45.2
RO
N/A
0: auto cal complete
1: calibration complete
2: auto cal in progress
3: manual cal in progress
3: Not Used by DVC6200f
5: upper position marked
6: lower position marked
7: calibration error
8: Performance Tuner
45.3
RO
N/A
active
9: Performance Tuner
Success
10: Performance Tuner
Error (No movement)
11: Performance Tuner
Error (Accessories
unstable)
12: Performance Tuner
Error (Other)
45.4
Range
Initial Value
1=Operating
0%
no bits set
-Continued-
Instruction Manual
D103412X012
Protect
Description
Category
Data Type: Enum (Uint8)
CAL
Resets to 1 after a write
N/A
Data Type: Uint8
Data Type: Bit String (2 bytes)
All bits set to 0 when mode changes
N/A
from OOS. 0 = FALSE,
1 = TRUE
Reserved