Table of Contents
Advertisement
Hardware Installation
You can use the following subsections to install the RocketLinx ES8509-XT.
•
Connect the Power and Ground
•
Connect the Digital Input and Relay Output
•
Mount the ES8509-XT
•
Connect the Ethernet Ports
•
Connect SFP Transceivers (Combo Ports 1-5)
•
LED Descriptions
on Page 14
•
Panel Layout
on Page 15
•
Reset Button
on Page 16
Connect the Power and Ground
Use the following procedure to connect the power and ground.
This switch is intended to be installed in a
RESTRICTED ACCESS LOCATION ONLY.
You can use the following procedure to connect power and the ground to the ES8509-XT.
1. Connect the DC power inputs.
a. Insert positive and negative wires (12-24AWG) into the PWR+ and PWR- contacts.
Note: Power should be disconnected from the power supply before connecting it to the switch.
Otherwise, your screw driver blade can inadvertently short your terminal connections to the
grounded enclosure.Tighten the wire-clamp screws to prevent the wires from coming loose.
Wiring Power Supplies
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
on Page 10
on Page 11
on Page 13
on Page 14
12 - 24AWG Wire
12 - 24AWG Wire
Power Supply
AC Power Input
10.5 - 60VDC
V-
V+
Power Supply
AC Power Input
10.5 - 60VDC
V-
V+
Hardware Installation - 9
Advertisement
Table of Contents
