Table of Contents
Advertisement
INTRODUCTION
The RocketLinx ES7510-XT is a ten port managed PoE Plus switch that
provides:
•
Eight 10/100BASE-TX PoE Plus ports that are IEEE 802.3af (15.4W)
and IEEE 802.3at two-event and IEEE 802.3at LLDP (30W) compliant.
The product also supports a forced powering feature to support non-
standard Power Devices (PDs).
•
Two Gigabit RJ45/SFP combo ports. The SFP ports support 100BASE-FX
and Gigabit fiber.
The ES7510-XT provides features needed for network control and security
in an industrial network environment. See the Comtrol website for detailed
product specifications and the product warranty.
INSTALLATION OVERVIEW
You can use the following overview to install the ES7510-XT. If you need more
detailed information, you can refer to the RocketLinx ES7510-XT User Guide
download on the site, which contains detailed installation and configuration
information.
Connecting the Power
The ES7510-XT provides redundant power inputs (PWR 1/2), which supports
reverse polarity protection, and accepts a positive or negative power source.
However, PWR1 and PWR2 must apply to the same
mode.
Note: Power should be disconnected
from the power supply before
connecting it to the switch.
Otherwise, your screwdriver blade
can inadvertently short your
terminal connections to the
grounded enclosure.
1.
Insert the positive and
negative wires into PWR+
and PWR- contacts. You
can connect a single
power supply or both
power supplies depending
on your requirements.
Wiring Positive
Power Supplies
-
+
-
+
12 - 24AWG Wire
12 - 24AWG Wire
Positive and negative power system inputs are both
accepted, but PWR1 and PWR2 must be in the same mode.
1
AC Power Input
Power Supply
V+
46-57VDC
(UL Listed)
V-
Power Consumption
Without PD load (maximum): 15W
PoE with PD load (maximum): 160W
AC Power Input
Power Supply
V+
46-57VDC
(UL Listed)
V-
Advertisement
Table of Contents
