Comtrol ROCKETLINX ES8509-XT User Manual page 162

Configuration Using the Command Line Interface (CLI)
VLAN Port Configuration (continued)
Switch# show running-config
......
!
interface gigabitethernet1
Display – Port
Egress Rule (Egress
rule, IP address,
status)
.......
interface vlan1
VLAN Configuration
Switch(config)# vlan 2
vlan 2 success
Switch(config)# interface vlan 2
Create VLAN (2)
Switch(config-if)#
Note: In the CLI configuration, you should first create a VLAN interface. Then you can
Switch(config)# no vlan 2
no vlan success
Remove VLAN
Note: You can only remove the VLAN when the VLAN is in unused mode.
Switch(config)# vlan 2
vlan 2 has exists
Switch(config-vlan)# name v2
VLAN Name
Switch(config-vlan)# no name
Note: Use no name to change the name to default name, VLAN VID.
Switch(config)# interface vlan 2
Switch(config-if)#
VLAN description
Switch(config-if)# description this is the VLAN 2
Switch(config-if)# no description
Switch(config)# interface vlan 2
Switch(config-if)#
IP address of the
Switch(config-if)# ip address 192.168.250.18/24
VLAN
Switch(config-if)# no ip address 192.168.250.8/24
address
Create multiple
Switch(config)# interface vlan 5-8
VLANs (VLAN 5-8)
Switch(config)# interface vlan 2
Shutdown VLAN
Switch(config-if)# shutdown
Switch(config-if)# no shutdown
162 - VLAN (CLI)
switchport access vlan 1
switchport access vlan 3
switchport trunk native vlan 2
ip address 192.168.250.8/24
no shutdown
start to add/remove ports. The default status of the created VLAN is unused
until you add member ports to it.
->Delete the description.
->Turn on the VLAN
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
->Delete the IP