Table of Contents
Advertisement
INTRODUCTION
The RocketLinx MP1204-XT is twelve port managed industrial switch that
provides:
•
Eight 10/100/1000BASE-T PoE (802.3af/at) ports
•
Four 100/1000 SFP ports
The MP1204-XT provides features needed for network control in an industrial
network environment. See the Comtrol website (www.comtrol.com) for
detailed product specifications and the product warranty.
INSTALLATION OVERVIEW
You can use the following information to install the MP1204-XT. If you need
more detailed information, you can refer to the RocketLinx MP1204-XT User
Guide on the download site (http://downloads.comtrol.com), which contains
detailed installation and configuration information.
Connect the Power Terminal Block
The MP1204-XT provides redundant
power inputs (PWR 1/2), which
supports reverse polarity protection,
and accepts a positive or negative
powersource (12V – 57V). However,
PWR1 and PWR2 must apply to the
same mode.
Note: Power should be disconnected
from the power supply before
connecting it to the switch.
Otherwise, your screwdriver blade
can inadvertently short your
terminal connections to the grounded enclosure.
1.
Insert the positive and negative wires into PWR+ and PWR- contacts. You
can connect a single power supply or both power supplies depending on
your requirements.
2.
Tighten the wire-clamp screws to prevent the wires from coming loose.
1
Advertisement
Table of Contents
