Table of Contents
Advertisement
Configuration Using the Command Line Interface (CLI)
If you selected SSH, click Yes.
•
Enter the user name (default = admin).
•
Enter the password (default = admin).
If you selected Telnet:
•
Enter the user name (default = admin).
•
Enter the password (default = admin).
All the commands you see in SSH are the same as the CLI commands you see through the RS-232 console.
For more information about using the CLI, see
Command Line Interface Introduction
The Command Line Interface (CLI) is the user interface to the ES8509-XT embedded software. You can view
the system information, show the status, configure the switch, and receive a response back from the system by
keying in a command.
There are several different command modes. Each command mode has its own access ability, available
command lines and uses different command lines to enter and exit. These modes are:
•
User EXEC Mode
on Page 135, which includes commands to ping or telnet to a remote device, and show
some basic information and to access Privileged EXEC mode
•
Privileged EXEC Mode
switch, show system information, save configuration, and access Global Configuration mode
•
Global Configuration Mode
to one of the Interface Configuration modes
•
(Port) Interface Configuration
•
(VLAN) Interface Configuration
VLAN
Refer to
Configuration Using the Command Line Interface (CLI)
134 - Command Line Interface Introduction
Command Line Interface Introduction
on Page 137, which provides a view current configuration, reset default, reload
on Page 138, which you can use configure all ES8509-XT features and access
on Page 139, which can be used to configure port settings
on Page 140, which can be used to configure the settings for a specific
on Page 134.
on Page 129 to access the CLI.
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
Advertisement
Table of Contents
