Table of Contents
Advertisement
INTRODUCTION
The RocketLinx ES8520-XT is a 20 port managed industrial switch that
provides:
•
Sixteen 10/100BASE-TX ports
•
Four Gigabit RJ45/SFP combo ports. The SFP ports support 100BASE-FX
and Gigabit fiber.
The ES8520-XT provides features needed for network control in an industrial
network environment. See the Comtrol website for detailed product
specifications and the product warranty.
INSTALLATION OVERVIEW
You can use the following overview to install the ES8520-XT. If you need more
detailed information, you can refer to the RocketLinx ES8520-XT User Guide
on the download site, which contains detailed installation and configuration
information.
Connecting the Power
The ES8520-XT provides redundant power inputs (PW 1/2), which supports
reverse polarity protection, and accepts a positive or negative power source.
However, PW1 and PW2 must apply to the same mode.
Note: Power should be disconnected from the power supply before connecting it to
the switch. Otherwise, your screwdriver blade can inadvertently short your terminal
connections to the grounded enclosure.
1.
Insert the positive and negative wires
into the PW+ and PW- contacts. You
can connect a single power supply or
both power supplies depending on your
requirements.
1
Advertisement
Table of Contents
