Table of Contents
Advertisement
IP Configuration Page
You can select to Enable or Disable the DHCP Client function. When the DHCP Client
function is enabled, an IP address is assigned to the switch from the network's DHCP
DHCP Client
server. In this mode, the default IP address is replaced by the one assigned by DHCP
server. If DHCP Client is disabled, then the IP address that you specified is used.
IP Address
You can assign the IP address reserved by your network for the ES8509-XT. If the DHCP
Default:
Client function is enabled, you do not need to assign an IP address to the ES8509-XT,
because it is overwritten by the DHCP server and displays here.
192.168.250.250
You can assign the subnet mask for the IP address here. If the DHCP Client function is
Subnet Mask
enabled, you do not need to assign the subnet mask. .
Default:
Note: In the CLI, the enabled bit of the subnet mask is used to represent the number
255.255.255.0
Default Gateway
You can assign the gateway for the switch here.
Default:
Note: In the CLI, use 0.0.0.0/0 to represent the default gateway.
192.168.250.1
The Domain Name System (DNS) is a hierarchical naming system built on a distributed
database for computers, services, or any resource connected to the Internet or a private
network. It associates various information with domain names assigned to each of the
DNS Server 1/2
participating entities. Most importantly, it translates domain names meaningful into the
numerical identifiers associated with networking equipment for the purpose of locating
and addressing these devices worldwide.
You can enter an IPv6 address for the ES8509-XT.
An IPv6 address is represented as eight groups of four hexadecimal digits, each group
representing 16 bits (two octets). The groups are separated by colons (:), and the length of
IPv6 Address
IPv6 address is 128bits.
The 64-bit interface identifier is automatically generated from the MAC address for the
ES8509-XT using the modified EUI-64 format.
Prefix Length
This IPv6 prefix specifies the size of a network or subnet. The default is 64.
The IPv6 default gateway IP address identifies the gateway (for example, a router) that
IPv6 Default
receives and forwards those packets whose addresses are unknown to the local network.
Gateway
The agent uses the default gateway address when sending alert packets to the
management workstation on a network other than the local network.
This table shows the IPv6 addresses that have been added to the management VLAN. To
IPv6 Address
remove an entry, click the check box next to it and then click the Remove button. To reload
the list, click the Reload button.
IPv6 Neighbor Table
Neighbor
The IPv6 Neighbor Table lists neighbors of the ES8509-XT.
Interface
The interface connected to the neighbor.
MAC address
This is the MAC address of the neighbor.
State
This displays the Neighbor Unreachability Detection (NUD) state of the neighbor entry.
Remove
Click the Remove button to remove an IPv6 configuration or IPv6 Neighbor Table entry.
Reload
Click the Reload button to reload IPv6 configuration.
Click Apply to apply the settings.
Apply
Note: You must Save the settings
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
displayed in the web management interface. For example, 8 represents: 255.0.0.0,16
represents: 255.255.0.0, 24 represents: 255.255.255.0.
ES8509-XT is powered off.
Configuration Using the Web Interface
(Page
127), if you want to maintain these settings if the
IP Configuration - 49
Advertisement
Table of Contents
